Table of Content

Open Access iconOpen Access

ARTICLE

crossmark

MODIFICATION OF PERFORATED PLATE IN FLUIDIZED-BED COMBUSTOR TO PROVIDE SUFFICIENT AIR SUPPLY IN THE COMBUSTION

Erdiwansyah Erdiwansyaha,d , Mahidin Mahidinb, Husni Husinb, Muhammad Faisalc, Usman Usmanc, Muhtadin Muhtadinc, Asri Ganib,*, Rizalman Mamate

a Doctoral Program, School of Engineering, Post Graduate Program, Universitas Syiah Kuala, Banda Aceh 23111, Indonesia
b Department of Chemical Engineering, Universitas Syiah Kuala, Banda Aceh 23111, Indonesia
c Department of Mechanical Engineering, Universitas Abulyatama Aceh, Aceh Besar 23372, Indonesia
d Faculty of Engineering, Universitas Serambi Mekkah, Banda Aceh 23245, Indonesia
e Faculty of Mechanical Engineering, Universiti Malaysia Pahang, 26600, Malaysia
* Corresponding author. Email: asri_gani@unsyiah.ac.id

Frontiers in Heat and Mass Transfer 2022, 18, 1-6. https://doi.org/10.5098/hmt.18.25

Abstract

The modification of the perforated plate applied in this study aims to provide sufficient air access into the combustion chamber. Burning experiments were carried out with three different types of fuel (such as palm kernel shell (PKS), oil palm midrib (OPM), and empty fruit bunches (EFB). The purpose of the experiment with the modification of the perforated plate is to investigate the combustion temperature and the rate of heat transfer in the boiler. The fluidized-bed combustor (FBC) combustion chamber is used as the combustion chamber. Experimental results were obtained at four different points using a Digital Thermometer with a thermocouple. The experimental results show that the highest heat transfer rate is obtained from PKS fuel of 8.258 W/m for the M-1 measurement point. The measurement results on the M-2 highest heat transfer rate were recorded from OPM fuel of 7.392 W/m. The highest combustion temperature is obtained from OPM fuel, which is 884o C for the M-1 measurement point. The combustion temperature of the PKS combustion process is slightly higher at 896o C. However, the combustion temperature produced during the combustion of PKS shows a less good trend than OPM. Overall, the fuel used in this test can be completely burned and unsaturated by providing sufficient air supply into the combustion chamber. Modification of the perforated plate with the addition of air supply in the combustion chamber is a novelty found in this study.

Keywords


Cite This Article

Erdiwansyah, E., Husin, H., Faisal, M., Usman, U., , M. et al. (2022). MODIFICATION OF PERFORATED PLATE IN FLUIDIZED-BED COMBUSTOR TO PROVIDE SUFFICIENT AIR SUPPLY IN THE COMBUSTION. Frontiers in Heat and Mass Transfer, 18(1), 1–6.



cc This work is licensed under a Creative Commons Attribution 4.0 International License , which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
  • 287

    View

  • 280

    Download

  • 0

    Like

Share Link